Tool Box Lock Instructions

1) Remove factory supplied cam lock located on the driver side of the tool box..

2) Replace with Lazy Action Lock

3) Install Cam on back of lock.

4) Attach one end of rod to cam and the other to the actuator. ( You may eventually need to cut the rod down)

5) Find a suitable location that also allows you to attach the adhesive plate to the tool box.

6) Actuator must be at least 4" from the cam to allow a full range of motion.


7) Note two threaded studs on the adhesive plate

8) Place mounting holes on actuator over the threaded studs and tighten nut until actuator is firmly in place.

9) Run electrical wires into the cab of the truck to appropriate door lock wires. Call for correct color codes.

10) Link to Operational Video - http://dynoproducts.net/locks/electbxlock/electoolbxlock_vid.htm